#15387 Fanuc ArcMate SR weld cell - 6 axis arm, 1550mm reach - RJ controller / pendant / licensed software - Preston Eastin two position turntable, 48" x 48", 500lb capacity - common steel baseplate 105" x 42" x 1" - operator's pedestal with E-Stop, Part Ready, Part Ready Cancel, Hold, Fault Reset, and Cycle Start push button switches - Miller Maxtron 450 power source and wire feeder - Binzel air cooled torch with safety breakaway - torch clean / anti-spatter spray / torch alignment station - wire guide / cable balancer for use with 1000lb spools or drums - perimeter safety fencing 178" x 84" - operator station safety mat or light curtain - available options: alternate power sources / wirefeeders aux axis drives manuals - complete set fixture design / fabrication on-site installation on-site training on-site programming and process development      This equipment is on our floor, under power, and available for inspection at your convenience. Please contact us for additional information, a formal quotation, and to arrange a visit.